Publicité
Selecting a TENS program
The TENS and EMS modes each support 20 pre-set programs, the FITNESS
mode supports 1 0 programs. All these programs feature different pre-set
pulse rates and pulse widths.
TENS programs
When using one of the 20 pre-set programs for pain relief, always start
with the lowest intensity and slowly increase until you feel some "tingling"
sensation. All programs are different and therefore cause different
sensations. At the very beginning, try all programs first and then select
the one that feels most pleasant. Never increase intensity to a level that
causes pain. Always remain below the level that causes discomfort. Start
with short sessions of 5 or 1 0 minutes until your body gets used to this kind
of stimulation.
Changing programs during a session will not reset the treatment time,
unless you reset the time manually as described above.
Press the "F" button (3) to select a treatment mode. By default, the display
will show mode (1) (TENS mode), and with each additional press of the
button the system will switch to EMS and FITNESS modes.
Note:
Use buttons (11) + and (13) - to change programs in any of the 3 modes.
To change the intensity of the selected program, use buttons (4) +/- for
channel 1 and (12) +/- for channel 2. Please refer to intensity displays (2)
and (6) as weil as frequency display (7).
You will feel the increase or reduction of intensity immediately after
Note:
configuration. Changing intensity will help you find the level most
appropriate for you.
For safety reasons, when changing the treatment mode or treatment
Note:
program during a session, the system will set the intensity level back
to "0'; and the display will change accordingly.
3 session per day are recommended.
Note:
51
Publicité
