Publicité
Battery-powered setting tool
Rivdom
eVNG 2
®
The manufacturer hereby declares that the named products satisfy the requirements of the following
regulations:
EC Machinery Directive 2006/42/EC Annex I
EMC Directive 2014/30/EU, RoHS Directive 2011/65/EU, Battery Directive 2006/66/EU
If the machine is modified without our knowledge and consent, this EC Declaration of Conformity will be
voided.
Most important applied harmonised standards:
2006/42/EC Annex I EMC Directive, 2014/30/EU, 2011/65/EU, EN 62841-1:2015+A11:2022,
EN IEC 55014-1:2021, EN IEC 55014-2:2021.
Name of the documentation officer:
Address of the documentation officer:
Neumünster, Germany, 2024-04-01
_____________________________________
Timm Salkowski
(Managing Director)
9 Troubleshooting
9.1
MESSAGES ON THE SCREEN
Screen message
None
None
Battery empty
Overload
Battery cold
Battery hot
Tool cold
Tool hot
Service
Emergency Mode
HONSEL Distribution GmbH & Co. KG
See address of the manufacturer
RGB LED
Description
Green
Yellow
Red
Red
Red
Red
Red
Red
Red
Red flashing
From serial number
xxxx.B39001 – xxxx.B39999
Tool is ready for operation
Tool in operation
Replace battery
Wait 10 seconds
Warm up battery
Replace battery
Warm up tool
Wait until setting tool has cooled down
This message appears when the setting tool has
set 300,000 fasteners. The message continues to
appear until the setting tool has been serviced by
HONSEL Service.
Setting tool in emergency mode
English | 55
Publicité
