Publicité
2.9.1.2 Variable trigger
The fastener is automatically screwed on when the trigger is pressed. The speed varies according to the
position of the trigger. Shown as "VT" in the status bar.
2.9.1.3 Threaded mandrel / threaded sleeve
Screwing on of the fastener starts automatically when the fastener is pressed against the threaded
mandrel or threaded sleeve. Shown as "M" in the status bar.
2.9.2 Setting Mode
The fastener can be set in either force-controlled or stroke-controlled mode.
2.9.2.1 Force
The fastener is set under force control. The setting tool sets the fastener with a preset force. Shown as
"F" in the status bar.
2.9.2.2 Stroke
The fastener is set under stroke control. The setting tool sets the fastener until a preset stroke is reached.
Shown as "S" in the status bar.
2.9.3 Emergency Mode
Emergency mode can be started if the fastener has tilted with the threaded mandrel / threaded sleeve
during the setting process and spindle out is no longer possible. The fastener can then be separated from
the threaded mandrel / threaded sleeve again in emergency mode.
3 Setup / settings
DANGER
Live parts
Serious injuries or even death due to electric shock
•
If the insulation is defective, switch off the power supply immediately.
•
Work on the electrical system may only be carried out by a qualified electrician.
•
Keep moisture away from live parts.
•
Keep the system closed.
•
Do not bypass or deactivate fuses.
WARNING
Parts flying out of the machine
Serious injuries or material damage
•
Do not point the machine towards persons.
•
Disconnect the machine from the power supply before changing tools or accessories.
•
Clamp the workpiece securely before starting work.
WARNING
Lack of protective equipment
Serious injuries or even death
•
Use only undamaged protective equipment.
•
Wear safety shoes during all work steps for commissioning, operation, cleaning,
maintenance or during replacement of components.
3.1
ATTACH BELT CLIP / RIVET APPLICATION PLATE
This work step is optional and only necessary if the belt clip or rivet application plate are
needed.
English | 39
Publicité
