Publicité
see figure c, Belt clip
No.
Designation
1
Belt clip (alternatively: rivet application plate)
2
Slot
3
Retaining screw
Precondition:
•
Belt clip / rivet application plate is needed.
1. Push the belt clip / rivet application plate into the slot.
2. Insert the retaining screw into the bore of the belt clip / rivet application plate.
3. Tighten the retaining screw using a screwdriver.
4. Check by hand whether the belt clip / rivet application plate is securely attached.
3.2
CHARGE BATTERY
The battery can be recharged at any time without shortening its service life. Interruption of
the charging cycle does not damage the battery.
See separate operating manual for the charger.
3.3
INSTALL THREADED MANDREL / THREADED SLEEVE AND NOSEPIECE
Installation requires no tools.
A threaded mandrel or threaded sleeve and a nosepiece with the same diameter must
always be installed.
Installation is described in the enclosed quick guide.
see figure b, Installation of threaded mandrel / threaded sleeve
No.
Designation
1
Union nut
2
Nosepiece
3
Union nut O-ring
4
Front sleeve with O-ring
5
Clamping sleeve
6
Threaded mandrel / threaded sleeve
7
Spindle adapter
8
Safety slide
9
Spring
1. Press the battery release button and remove the battery from the setting tool.
40 | English
Publicité
