Publicité
4.5
MANUAL SPINDLE OUT
Should the set spindle out time be too short or if a fastener with a longer thread than the
fastener with which the setting tool was set up was used, the fastener can be unscrewed
manually.
Precondition:
•
A fastener was set immediately beforehand and the fastener has not yet been completely spindled
out after the end of the setting process.
1. Press the "Arrow up" key and press the trigger at the same time.
»
The fastener is spindled out.
2. Release the "Arrow up" key and the trigger as soon as the fastener has been completely spindled out.
»
The setting tool is ready to set the next fastener.
4.6
EMERGENCY MODE / THREADED MANDREL OR THREADED SLEEVE IS
TILTED
If the threaded mandrel / threaded sleeve is tilted and cannot be unscrewed, the
emergency mode can be started on the setting tool to manually remove the threaded
mandrel / threaded sleeve from the setting tool.
Precondition:
•
Emergency mode is activated, see chapter 3.5.2.5
•
The unlocked starting mask / working mask is displayed on the screen.
•
Threaded mandrel / threaded sleeve has tilted in the setting tool.
•
A W/F 5 open-jaw wrench or socket wrench is available.
Emergency mode: activated
1. Press the "Arrow up" key and the "Arrow down" key at the same time.
Emergency mode: de-activated
1. Select the menu item, see chapter 3.5.2, with the user or admin access right
»
The Emergency Mode menu with work instructions appears on the screen.
2. Unscrew the union nut from the front sleeve by hand in anti-clockwise direction.
3. Press the OK key.
»
The tool moves the threaded mandrel or threaded sleeve back into the front end position.
4. Press the battery release button and remove the battery from the setting tool.
5. Unscrew the nosepiece by hand in anti-clockwise direction and remove it.
6. Screw the union nut onto the front sleeve again in clockwise direction.
7. Hold the tool with one hand.
8. With the other hand, unscrew the clamping sleeve by hand in anti-clockwise direction and remove.
9. Remove the threaded mandrel / threaded sleeve from the clamping sleeve using a W/F 5 open-jaw
wrench or socket wrench.
10. Inspect the threaded mandrel / threaded sleeve for damage and replace with a new threaded mandrel
or threaded sleeve, if necessary.
11. Assemble all the parts again.
12. Discard the used fastener.
13. Insert the battery into the setting tool again.
»
The setting tool is ready for operation.
English | 51
Publicité
