Publicité
2. If a nosepiece is already installed on the setting tool, unscrew it by hand in anti-clockwise direction
and remove.
3. Unscrew the union nut by hand in anti-clockwise direction and remove.
»
The front sleeve is released.
5. Remove the front sleeve with O-ring.
6. Press the safety slide against the spring and hold.
7. Unscrew the clamping sleeve by hand in anti-clockwise direction and remove.
8. Release the safety slide again.
9. If a threaded mandrel or threaded sleeve is already installed in the setting tool, remove the threaded
mandrel / threaded sleeve.
10. Push the desired threaded mandrel or threaded sleeve into the spindle adapter.
11. Push the clamping sleeve onto the threaded mandrel or threaded sleeve.
12. Screw the clamping sleeve with threaded mandrel or threaded sleeve onto the spindle adapter by
hand in clockwise direction until the clamping sleeve engages in the safety slide.
13. Push the front sleeve with O-ring onto the clamping sleeve and threaded mandrel / threaded sleeve.
14. Push on the union nut and tighten by hand in clockwise direction.
The nosepiece used must have the same diameter as the threaded mandrel or threaded
sleeve used.
15. Screw the matching nosepiece onto the front sleeve by hand in clockwise direction.
16. Insert the battery into the setting tool again.
»
The setting tool is ready for operation.
3.4
SET UP THE SETTING TOOL FOR THE SETTING PROCESS
There are different setup modes and access rights depending on the user's task, skills and level of
knowledge.
3.4.1 Setup mode
The setting tool features many setting options.
For precise operation, the setting tool offers two setup modes with varying scopes based on the level of
knowledge and requirements:
•
Basic Setup
•
Pro Setup
Basic Setup
In the Basic Setup, the setting options and menu items are reduced to a minimum. Some settings are
defined at the factory (e.g. spindle mode or spindle direction). The setting tool is ready for use in just a
few steps.
Maximum menu (admin mode)
•
Setup
•
Load Setup
•
Emergency Mode
Pro Setup
The Pro Setup provides access to all menu items.
This mode allows for subsequent optimisation of the working method (e.g., triggering via the trigger) or
setup for special requirements (e.g., left-hand thread). The threaded mandrel/sleeve direction and the
pull speed can, among other things, also be set during setup. The difference is mainly noticeable with full
access rights (admin mode).
Maximum menu (admin mode)
•
Tool Settings
•
Work Settings
•
Load Setup
•
Service
•
Un-/Lock
•
Emergency Mode
English | 41
Publicité
