Publicité
•
The setting tool is unlocked, see chapter 3.5.6.
1. Insert the battery into the setting tool.
2. Press the trigger briefly.
The locked starting mask / working mask appears on the screen.
»
The "WAITING" status appears on the screen.
»
3. Press the trigger briefly.
The setting tool performs a calibration run.
»
The "READY" status appears on the screen.
»
4. Press the trigger.
»
The fastener is automatically screwed on and the tool stops as soon as the fastener has been
completely screwed on.
4.3
SPIN ON FASTENER USING THREADED MANDREL / THREADED SLEEVE
Precondition:
•
The desired threaded mandrel or threaded sleeve and the desired nosepiece are fitted,
see chapter 3.3.
•
The setting tool has been set up and the threaded mandrel has been selected as the spindle mode,
see chapter 2.9.1.
•
The setting tool is unlocked, see chapter 3.5.6.
1. Insert the battery into the setting tool.
2. Press the trigger briefly.
The locked starting mask / working mask appears on the screen.
»
The "WAITING" status appears on the screen.
»
3. Press the trigger briefly.
The setting tool performs a calibration run.
»
The "READY" status appears on the screen.
»
4. Press the fastener inwards onto the threaded mandrel or threaded sleeve.
»
The fastener is automatically screwed on and the tool stops as soon as the fastener has been
completely screwed on.
4.4
SETTING FASTENERS
ATTENTION
Incorrect setting of fasteners
Material damage
•
Position the fastener at right angles to the part.
•
Observe the correct drill hole size.
With our fasteners, the drill hole size for the fastener is indicated on the packaging of
the respective fastener. If fasteners from other manufacturers are used, contact the
manufacturer for details of the drill hole sizes.
Precondition:
•
The desired threaded mandrel or threaded sleeve and the desired nosepiece are fitted,
see chapter 3.3.
•
The setting tool has been set up, see chapter 3.4.
•
There is a drill hole for the fastener in the part.
•
The setting tool is unlocked, see chapter 3.5.6.
1. Spin on the fastener, see chapter 4.2 or see chapter 4.3.
5. Insert the fitted fastener into the workpiece at a right angle until the setting head is flush.
6. Press the trigger.
»
The fastener is set.
»
The setting tool is ready to set the next fastener.
50 | English
Publicité
