Publicité
If a force value of less than 5.5 is entered, the setting tool prompts you to also enter a
stroke value.
Fastener
material
Aluminium
-
Steel
7
Stainless steel
9
If the setting value selected from the table leads to a poor setting result during the initial setup, increase
the setting value step by step with the values given below until an optimum setting result is obtained.
Colour range for the
setting value
Light grey
White
Dark grey
Setting values for stroke
The stroke values given are setting values without units and do not correspond to the
actual stroke executed in mm.
The same setting values for the strokes apply for all fastener materials.
Fastener diameter
1.5
2.0
2.5
Gradual adjustment for all stroke setting values: 0.1 to 0.2
10. When the trigger is pressed, the fastener is set and automatically spindled out. A setting test should
always be performed in the workpiece.
11. The setting result (OK/NOK; see Fig. d) is now evaluated via the arrow keys. If NOK is confirmed,
adjustment of the setting speed and force or stroke is automatically enabled. This step is repeated
until the setting result is evaluated as OK.
12. Finally, the settings can be saved to a memory location (1-99).
3.5.3.1.2 Adjust / Save
All the changed settings can be subsequently saved and a new memory location assigned in this menu.
This includes, e.g., the setting speed, force or stroke values or the threaded mandrel direction.
3.5.3.1.3 Spindle Mode
Spindle mode can be adjusted, see chapter 2.9.1.
3.5.3.1.4 Import File
Up to 99 tool configurations can be imported in this menu.
The precondition is that a "presets.csv" file is saved on the SD card (see chapter 3.5.3.1.5).
Fastener diameter
7
8
14 22 24 25
10 11
18 23 33 57
12 15 32 45 70 82
Gradual adjustment
0.1 to 0.2
0.2 to 0.5
0.5 to 1.0
3.5
4.5
5.5
6.5
English | 47
Publicité
