Publicité
□
Press the SET button 13 to confirm the set value.
This will take you to the next setting.
● Activate/dim display lighting
For permanent display illumination, connect the USB connection cable 2 to the
power unit 3 . Plug the USB connection cable 2 into the coaxial power socket
and the power unit 3 into a properly installed socket.
9
The display illumination is not active during the DCF radio signal
search.
Battery operation:
Press the SNOOZE / LIGHT button 5 . The display is illuminated for approx. 10
seconds.
Mains operation:
Press the SNOOZE / LIGHT button 5 to toggle between high, dimmed or no
display illumination.
● MAX/MIN values
Once the batteries are inserted, the device saves the maximum and minimum
temperature and air humidity values.
□
Press the arrow up button 14 .
The display shows "MAX" 30 .
The highest measured room temperature 37 and the highest temper
ature of the outdoor sensor 29 are displayed.
The highest measured indoor air humidity 35 and highest outdoor
sensor humidity 32 are displayed.
Operation
GB/IE/NI
23
Publicité
