Publicité
Operation
● Switching the display of the added outdoor
sensors
Note: The automatic channel change function switches between the channels of
the connected outdoor sensors every three seconds.
□
Press the CH button 19 .
The channel display 42 changes the outdoor sensor channel (1, 2 or
3) with every push of the button and activates the automatic channel
change function with another push of the button ( 41 is shown on the
display).
If you have assigned the outdoor sensor to the selected channel, the outdoor sensor
data is displayed.
● Adding an outdoor sensor
Note: You can connect up to three outdoor sensors to the radio-controlled
weather station. Additional outdoor sensors are available from the order service.
□
Briefly press the CH button 19 .
The radio channel switches. The currently selected channel is
displayed in the channel display icon 42 .
□
Open the battery compartment 23 on the back of the outdoor sensor by
sliding the battery compartment lid 24 in the direction of the arrow.
□
Use a thin object for assistance.
□
Set the channel selection switch 22 to the same channel.
□
Keep the CH button 19 depressed until the RF signal icon 58 lights up.
□
Use a thin object for assistance.
□
Press the TX button 21 to establish the connection manually.
Connection is established. The temperature and air humidity are
displayed on the radio-controlled weather station and on the
outdoor sensor.
28
GB/IE/NI
Publicité
