Husqvarna K 760 Cut-n-Break Manuel D'utilisation page 9

• Before you refuel, open the fuel tank cap slowly and
release the pressure carefully.
• Fuel on your skin can cause injury. If you get fuel on
your skin, use soap and water to remove the fuel.
• If you spill fuel on your clothing, change clothing
immediately.
• Tighten the fuel tank cap fully. If the fuel tank cap is
not correctly tightened, the vibrations in the product
can loosen it and cause leakage of fuel and fuel
fumes. Fuel and fuel fumes are a risk of fire.
• Before you start the product, move the product to a
minimum of 3 m/10 ft from where you refueled.
Min
• Do not start the product if there is fuel or oil spilled
on the product. Remove the unwanted fuel and oil
and let the product dry before you start the engine.
• Examine the engine for leaks regularly. If there are
leaks in the fuel system, do not start the engine until
the leaks are repaired.
• Keep fuel in approved containers only.
Cutting blades
WARNING:
gloves when you assemble the product.
WARNING:
and cause injury to the operator.
WARNING:
for cracks, lost segments distortion or
unbalance prior to use and immediately after
striking an unintended object. Do not use a
damaged cutting blade. After inspecting and
installing the cutting blade, position yourself
and bystanders away from the plane of the
rotating cutting blade and run the power tool
at maximum no load speed for one minute.
WARNING:
manufacturer gives warnings and
recommendations for the operation and
correct maintenance of the cutting blade.
Those warnings are supplied with the cutting
2444 - 001 - 23.05.2024
Assembly
Always use protective
A cutting blade can break
Examine the cutting blade
The cutting blade
• When the product and fuel is in storage, make sure
that fuel and fuel fumes cannot cause damage, fire
and explosion.
• Drain the fuel in an approved container outdoors and
away from sparks and flames.
Safety instructions for maintenance
WARNING:
instructions that follow before you use the
product.
• Make sure that the engine is off and that the stop
switch is in STOP position.
• Use personal protective equipment. Refer to
Personal protective equipment on page 6 .
• If the maintenance is not done correctly and
regularly, the risk of injury and damage to the
product increases.
• Only do the maintenance as given in this operator's
manual. Let an approved service center do all other
servicing.
• Let an approved HUSQVARNA service agent do
servicing on the product regularly.
• Replace damaged, worn or broken parts.
• Always use original accessories.
blade. Read and obey the instructions that
are supplied with the cutting blade.
Note:
Make sure to only use diamond blades
from Husqvarna that are made for the Cut-n-Break
technology. The blades have an integrated belt pulley
and are approved for hand held cutting.
Diamond blades
WARNING:
blade to cut plastic material. The heat
produced during cutting may melt the plastic
and it can stick to the cutting blade and
cause a kickback.
WARNING:
very hot when used. An overheated blade
is a result of improper use, and may
cause deformation of the blade, resulting in
damage and injuries.
WARNING:
sparks that may cause fire. Do not use the
product near ignitable substances or gases.
Read the warning
Never use a diamond
Diamond blades become
Cutting metal generates
9