Husqvarna K 760 Cut-n-Break Manuel D'utilisation page 12

1. Secure the pipe so it does not move or roll during
cutting.
2. Cut section "I" of the pipe.
III
3. Ensure that the cut opens to avoid pinching.
4. Move to side II and cut from section I to bottom of
the pipe.
5. Move to side III and cut the remaining part of the
pipe ending at the bottom.
To prevent a kickback
WARNING:
there is a risk of kickback. Take care when
using your power cutter and make sure that
the blade is never pinched in the kickback
zone.
WARNING:
the blade in an existing cut.
12
I
II
Avoid situations where
Be careful when you put
WARNING:
work piece cannot move during a cutting
operation.
WARNING:
working technique can eliminate kickback
and its dangers.
• Always support the work of piece so that the cut can
keep open when cutting through. When the cut is
open there is no kickback. If the cut is closed and
pinches the blade, there is a risk of kickback.
Basic working techniques
WARNING:
to one side. This can prevent the free
movement of the cutting blade. The cutting
blade can break and cause injury to the
operator or bystanders.
WARNING:
of the cutting blade. The cutting blade can
break and cause injury to the operator or
bystanders. Only use the cutting edge.
WARNING:
blade is installed correctly and does not
show signs of damage.
WARNING:
existing cut made by a different blade, make
a sure that the slot is not thinner than your
blade as that can result in binding in the
cutting slot and a kickback.
WARNING:
sparks that can cause fire. Do not use the
product near flammable material or gases.
• Do a check that the correct cutting blade is used for
the material to be cut. Refer to
page 9 for instructions.
• Do not cut asbestos materials.
• Keep a safe distance to the cutting blade when the
engine operates.
Make sure that the
Only you and proper
Do not pull the product
Do not grind with the side
Make sure that the cutting
Before cutting in an
Cutting metal generates
Cutting blades on
2444 - 001 - 23.05.2024