Husqvarna K 760 Cut-n-Break Manuel D'utilisation page 23

2. Hold the starter rope pulley (A) with your thumb.
B
A
C
3. Put the starter rope in the notch (B) and wind it up
around the metal sleeve (C).
4. Pull out the starter rope (A).
A
5. Put your thumb on the starter pulley (B) to keep the
starter rope pulled out.
6. Release the starter rope from the notch.
2444 - 001 - 23.05.2024
B
7. Remove your thumb to release the starter pulley (A)
and let the starter rope (B) wind up on the pulley.
8. Pull out the starter rope fully to do a check that the
recoil spring is not at its end position. Make sure that
the starter pulley can be turned half a turn or more
before the recoil spring stops the movements.
To remove the spring assembly
WARNING:
when you remove the spring assembly.
There is a risk for eye injury, especially if a
spring is broken.
1. Remove the 2 screws on the spring assembly.
2. Push the 2 brackets on the snap locks with a
screwdriver.
To clean the spring assembly
CAUTION:
from the assembly.
1. Blow the spring with compressed air until it is clean.
2. Apply a light oil to the spring.
To attach the spring assembly
• Assemble in the opposite sequence of
the spring assembly on page 23 .
B
A
Always use eye protection
Do not remove the spring
To remove
23