Husqvarna K 760 Cut-n-Break Manuel D'utilisation page 20

2. Remove the blades. Refer to
blades on page 18 .
3. Remove the cover.
4. Remove the drive belt from the front of the cutting
arm.
5. Loosen the water hose (A). Slide back the bar and
remove the drive belt.
20
To replace the cutting
A
6. Remove the cutting arm by pulling it straight out from
the product.
7. Loosen the 6 screws holding the belt cover on the
cutting arm.
A
8. Remove the drive belt and put in the new one.
9. Install the cutting arm with the blade cover.
Note:
Make sure that the screw holes on the bar
are aligned with the holes on the belt cover.
10. Tighten the drive belt. Refer to
of the drive belt on page 21 .
To adjust the tension
2444 - 001 - 23.05.2024