Husqvarna K 760 Cut-n-Break Manuel D'utilisation page 10

Note:
Diamond blades are available in several
hardness classes.
Note:
Sharpen the blade by cutting soft material such
as sandstone or block.
• Always use a sharp diamond blade.
• Diamond blades can become dull when the wrong
feeding pressure is used or when cutting certain
materials such as heavily reinforced concrete.
Working with a dull diamond blade causes
overheating, which can result in the diamond
segments coming loose.
• Diamond blades consist of a steel core provided with
segments that contain industrial diamonds.
• Diamond blades are ideal for masonry, reinforced
concrete and other composite materials.
• Diamond blades ensure lower costs per cutting
operation, fewer blade changes and a constant
cutting depth.
• Special blades should be used when cutting metal.
Ask your dealer for help in choosing the right
product.
• When using diamond blade make sure that it rotates
in the direction indicated by the arrow on the blade.
Introduction
WARNING:
safety chapter before you use the product.
Kickback
WARNING:
can be very violent. The power cutter can be
thrown up and back towards the user in a
rotating motion causing serious or even fatal
injury. It is vital to understand what causes
10
Operation
Read and understand the
Kickbacks are sudden and
Water cooling system
WARNING:
diamond blades with water to prevent the
blades from becoming too hot. Heat can
deform the diamond blade which can result
in damage to the product and the operator.
Always use water during operation to keep the
temperature of the diamond blades down. The water
cooling system also increases the lifetime of the
diamond blades and prevents dust buildup.
Make sure that the water supply is not clogged.
Cutting blade vibration
CAUTION:
with too much force, the cutting blade
can become too hot, bend and cause
vibrations. Use the product with less force.
If the vibrations continue, replace the cutting
blade.
kickback and how to avoid it before using
the product.
Kickback is the sudden upward motion that can occur
if the blade is pinched or stalled in the kickback
zone. Most kickbacks are small and pose little danger.
However a kickback can also be very violent and throw
the power cutter up and back towards the user in a
rotating motion causing serious or even fatal injury.
Reactive force
A reactive force is always present when cutting. The
force pulls the product in the opposite direction to the
blade rotation. Most of the time this force is insignificant.
If the blade is pinched or stalled, the reactive force will
Make sure to cool the
If you use the product
2444 - 001 - 23.05.2024