Husqvarna K 760 Cut-n-Break Manuel D'utilisation page 29

Equivalent vibration levels, a
2
Front handle, m/s
2
Rear handle, m/s
Exhaust emissions (CO2 EU V)
2-stroke engine
Recommended cutting blade
dimensions
Cutting blade diameter,
mm.
230
Noise and vibration declaration
statement
These declared values were obtained by laboratory
type testing in accordance with the stated directive or
standards and are suitable for comparison with the
declared values of other products tested in accordance
with the same directive or standards. These declared
values are not suitable for use in risk assessments
and values measured in individual work places may
be higher. The actual exposure values and risk of
harm experienced by an individual user are unique and
depend upon the way the user works, in what material
the product is used, as well as upon the exposure time
and the physical condition of the user, and the condition
of the product.
3
Equivalent vibration level, according to EN ISO 19432-1, is calculated as the time-weighted energy total for
vibration levels in different work conditions. Reported data for equivalent vibration level has a typical statistical
dispersion (standard deviation) of 1m/s
4
This CO2 measurement results from testing over a fixed test cycle under laboratory conditions a(n)(parent)
engine representative of the engine type (engine family) and shall not imply or express any guarantee of the
performance of a particular engine.
2444 - 001 - 23.05.2024
3
hveq
4
Max. cutting depth, mm.
400
2
.
1.9
2.8
711 g/kWh
Max. peripheral speed, m/s Max. speed of output shaft,
80
rpm
5900
29