Husqvarna K 760 Cut-n-Break Manuel D'utilisation page 18

Clean
Function inspection
Replace
Safety devices on the product on page 6 .
* Refer to
Cutting blades on page 9 .
** Refer to
To clean externally
• Flush the product externally with clean water after
each day of operation. If it is necessary, use a brush.
To clean the air intake
CAUTION:
makes the product too hot. This can cause
damage to the piston and cylinder.
• Clean the air intake if it is necessary.
• Remove blockage, dirt and dust with a brush.
18
Daily
External cleaning
Cold air intake
General inspection
Fuel leaks
Water delivery system
Throttle lockout*
Stop switch*
Blade guard and spray guard*
Cutting blade**
A dirty or blocked air intake
Weekly
Vibration damping system*
Muffler*
Drive belt
Carburetor
Starter housing
To replace the cutting blades
WARNING:
is off and that the stop switch is in the STOP
position.
WARNING:
gloves when you replace the blades.
CAUTION:
when you replace the blades
The blades have integrated belt pulley halves and are to
be chamged in pairs.
1. Turn the bar nuts 1 turn counterclockwise.
Monthly Yearly
Spark plug
Fuel tank
Fuel system
Air filter
Clutch
Fuel filter
Make sure that the engine
Always use protective
Always replace the screw kit
2444 - 001 - 23.05.2024