Husqvarna K 760 Cut-n-Break Manuel D'utilisation page 7

• Do a check of the safety devices regularly. If the
safety devices are damaged or do not operate
correctly, speak to your HUSQVARNA approved
service agent.
• Do not change the safety devices.
• Do not use the product if protective plates, protective
covers, safety switches or other protective devices
are damaged or not attached.
Throttle trigger lockout
The throttle trigger lockout prevents accidental operation
of the throttle trigger. If you put your hand around
the handle and push the throttle trigger lockout (A),
it releases the throttle trigger (B). If you release the
handle, the throttle trigger and the throttle trigger lockout
move back to their initial positions. This function locks
the throttle trigger at idle speed.
B
To do a check of the throttle trigger lockout
1. Make sure that the throttle trigger is locked at the
idle position when the throttle trigger lockout is
released.
2. Push the throttle trigger lockout and make sure that it
goes back when you release it.
2444 - 001 - 23.05.2024
A
3. Make sure that the throttle trigger and throttle trigger
lockout move freely and that the return springs
operate correctly.
4. Start the product and apply full throttle.
5. Release the throttle control and make sure that the
cutting blade stops and stays stationary.
6. If the cutting blade rotates at idle position, adjust the
idle speed. Refer to
24 .
To do a check of the stop switch
1. Start the engine. Refer to
cold engine on page 15
2. Push the stop switch to the STOP position. The
engine must stop.
Blade guards/Spray guard
WARNING:
guards are correctly attached before starting
the product.
These guards are installed above and below the cutting
blades. The guards prevents injury if parts of the blades
To adjust the idle speed on page
To start the product with a
Always make sure that the
7