Putting the Units into Operation
4 Putting the Units into Operation
Safety information
Attention: It is essential to read the Safety Information in Chapter 1 before starting up.
The data transmitted (image and/or sound) can be received publicly in the reception range!
Checking the package contents
The package contains:
1 camera unit
1 monitor unit
1 lithium−ion battery for the monitor
Putting the monitor into operation
Attention: Position the monitor unit with a minimum distance of 1 m to other electronic
devices, otherwise there is a risk of mutual disturbance.
Inserting the battery
1. Open the battery compartment on the rear side of
the monitor: Slide the battery compartment cover
opposite to the direction of the arrow.
2. Insert the battery paying attention to correct polarity.
Important: The metallic contacts on the battery and
in the monitor must make contact.
3. Slide the battery compartment cover in the direction
of the arrow until it latches in place.
Connecting the monitor
Connect the monitor unit as illustrated in
the diagram. For safety reasons, only use
the power adapter plug supplied.
Attention: Use one of the power
adapter plugs supplied contain-
ing the output data 6 V, 800 mA
for the monitor unit.
To switch the monitor on, slide the On/Off slid-
ing switch to the ON position.
The battery is charged as soon as the power adapter plug is connected.
The battery charge status is indicated in the icon bar of the monitor when switched on.
The green segments run through the battery icon in the icon bar in the display. When the battery is
fully charged, the battery icon is filled fully in green.
When charging the battery for the first time, it should be charged for at least 4 hours without
interruption. This lengthens the service life of the battery!
64
39
40
2 power adapter plugs
1 hook and loop strap (for camera installation)
1 operating manual
Mains power outlet