Operating The Monitor - switel BCF 817 Mode D'emploi

Operating the Monitor

6 Operating the Monitor
Check the camera and monitor units are working properly each time before the equipment is
put into operation.
Switching the monitor on
Slide the On/Off sliding switch to its ON position.
The On/Off LED lights up green. The icon bar appears in the display. The monitor is now in Monitoring
mode and is operational.
Switching the monitor off
Slide the On/Off sliding switch to its OFF position.
The On/Off LED goes out. The display goes out.
Adjusting the volume on the monitor
Use the Arrow up/down buttons to change the volume at which the sounds detected in the room where
the camera stands are played. There are 5 volume levels available. The volume can also be switched
off.
S
Press the Arrow up button to raise the volume.
S
Press the Arrow down button to lower the volume or switch it off.
The volume level currently selected is indicated in the icon bar while altering the volume. If the volume
is switched off, the corresponding icon appears continuously in the icon bar (crossed−out loud-
speaker).
Speak function
You can speak into the monitor unit and be heard from the camera unit, e.g. to calm the baby or speak
to a person in the room being monitored.
1. Press and hold the Monitoring/Speak button on the monitor.
2. Speak into the microphone on the monitor.
3. Release the Monitoring/Speak button in order to be able to hear sounds from the room being
monitored again.
Zooming the image section
In order to be able to see more details, you can enlarge (zoom) a section of the image in the display.
One zoom level is available.
1. To zoom in, press and hold the Feed alert / Zoom / Register button on the monitor.
2. Press the Arrow up / down / left and right buttons to move the zoomed image section and select
the area you want to see in more detail.
3. To zoom out, press and hold the Feed alert / Zoom / Register button on the monitor.
When the zoom function is currently selected, the magnifying glass icon appears in the icon bar.
Baby feed alert
This function can be used to remind you to feed a baby at fixed, regular intervals.
Activating the baby feed alert
To activate the baby feed alert, press the Feed alert / Zoom / Register button on the monitor, several
times if necessary, until the time interval of your choice appears in the icon bar behind the baby bottle
icon.
The time interval is increased by 30 minutes each time the button is pressed and can be set to maxi-
mally 4:00 hours.
When the set time is reached, a continuous acoustic alarm signal is issued for maximally 1 minute and
the Feed time arrives" message flashes in the display.
68
43
44