Putting The Units Into Operation; Safety Information; Checking The Package Contents; Connecting The Transmitter - switel BCF800 Mode D'emploi

Putting the Units into Operation

3 Putting the Units into Operation

Safety information

Attention: It is essential to read the Safety Information in Chapter 1 before starting up.
The data transmitted (image and/or sound) can be received publicly in the reception range!

Checking the package contents

The package contains:
one camera unit
two power adapter plugs

Connecting the transmitter

Attention: Position the transmitter with a minimum distance of 1 m to other electronic devices,
otherwise there is a risk of mutual disturbance.
Operating with a power adapter plug
Connect the transmitter as illustrated in the diagram. For safety reasons, only use the power adapter
plug supplied.
Mains power outlet
Attention: Use the power adapter plug labelled Model No. CSD 0600300G with output data:
6 V, 300 mA, for the transmitter.
Operation with batteries or rechargeable batteries
Open the battery compartment on the rear side of the
transmitter.
Insert the rechargeable or standard batteries paying atten-
tion to correct polarity. Refer to the diagrams in the battery
compartment.
Close the battery compartment again.
The transmitter can be operated with 4 AAA" batteries (not contained in the material supplied)
or with rechargeable batteries of the same type. Please remember that the batteries cannot
be recharged directly in the device.
A commercially available charging unit is required.
The Power LED lights up red continuously when the battery charge becomes too low. The batteries
must be recharged/replaced.
40
8
(transmitter)
one monitor unit
(receiver)
one belt clip
4 rechargeable batteries (AAA)
for the receiver
an operating manual