Camera Setup; Loading The Batteries; Using Ac Power - switel BCF4161 Mode D'emploi

Setup
1

Camera Setup

1
.1 Power Supply
The camera uses either 4 AAA-Size batteries (alkaline battery recommended)
or the household AC power current.

Loading the Batteries

1.Open the battery compartment cover on the bottom of the camera. See Fig. 3.
2.Insert 4 AAA-size batteries (follow the plus (+) and minus (-) signs inside
the battery compartment). See Fig. 3.
3.Close the battery compartment cover, and make sure it is locked securely.
Note 1: Do not mix old batteries with new ones.
Note 2: Remove the batteries from the camera if you do not plan to use it for
4.Slide the POWER switch to the ON position. The LED on the camera
will light up ( red light). See Fig. 3.
Note : When the battery is low, the LED light will start blinking.

Using AC Power

1.Plug one end of the provided power adapter into a wall outlet and the other end
into the bottom of the camera. See Fig. 4.
Note: Use the adapter labeled OUTPUT: 6V DC with the camera.
2.Slide the ON/OFF switch to the ON position. The LED on the camera should
light up (red light). See Fig. 4.
1
.2 Fine Tuning
Place the camera in a convenient location, point the lens towards the observation
area and adjust the angle by rotating the lens head. See Fig. 5.
1
Fixing the camera
.3
You can use the tripod to adjust the angle of the camera. See Fig. 6.
1
.4 Night light
Press the night light button, the night light LEDs will remain ON. See Fig. 7.
2
a prolonged period of time.