switel BCF 817 Mode D'emploi page 66

Putting the Units into Operation
Registering the camera on the monitor (registration process)
The monitor and camera are already registered with each other at the factory.
However, up to 4 cameras can be registered on the monitor. Other cameras can be registered on
the monitor as follows:
1. Switch the monitor on.
2. Switch the (new) camera off.
3. Press and hold the Feed alert / Zoom / Register button on the monitor and switch the monitor off
and on again using the On/Off sliding switch. Continue to press and hold the Feed alert / Zoom /
Register button until the Registration screen appears in the display (white text on black
background).
4. When the Registration screen appears on the monitor, use the Arrow up or Arrow down button to
select the channel (CH) on which the new camera should operate.
5. Then, with the Registration screen still in the monitor display, press the Arrow right or Arrow left
button to select Pair" (for pairing" = registration).
6. Set the new camera to Registration mode: Press the On/Off button and Lower volume / Register
button on the new camera simultaneously for 2 seconds. When the new camera is in Registration
mode, the On/Off LED on the camera flashes.
7. Press the Menu/OK button on the monitor to complete the registration process. When the
registration process is completed successfully, the corresponding message appears in the display.
8. Conclude the registration process by pressing the Menu/OK button. The Registration screen
displays the current status.
9. When the Registration screen appears on the monitor, use the Arrow up or Arrow down button to
select EXIT" and confirm the selection by pressing the Menu/OK button to exit from the
Registration screen.
When a connection is established, the image viewed by the camera lens appears in the display.
Deregistering the camera from the monitor (deregistration process)
1. Switch the monitor on.
2. Press and hold the Feed alert / Zoom / Register button on the monitor and switch the monitor off
and on again using the On/Off sliding switch. Continue to press and hold the Feed alert / Zoom /
Register button until the Registration screen appears in the display (white text on black
background).
3. When the Registration screen appears on the monitor, use the Arrow up or Arrow down button to
select the channel (CH) to be deleted.
4. Then, with the Registration screen still in the monitor display, press the Arrow right or Arrow left
button to select Del" (for delete" = deregister).
5. Press the Menu/OK button on the monitor.
6. Conclude the deregistration process by pressing the Menu/OK button. The Registration screen
displays the current status.
7. When the Registration screen appears on the monitor, use the Arrow up or Arrow down button to
select EXIT" and confirm the selection by pressing the Menu/OK button to exit from the
Registration screen.
Selecting the camera
If several cameras are registered on the monitor, press the Channel selection button on the monitor to
select between the different cameras.
66
42
41