Gear Oil - Suzuki DF250AP Manuel Du Propriétaire

7. Check the engine oil level.
NOTE:
To avoid incorrect measurement of engine oil
level, check oil level only when the engine has
cooled.
8. Reinstall the oil filler cap.
 WARNING
Engine oil can cause injury to people or
pets. Repeated, prolonged contact with
used engine oil may cause skin cancer.
Even brief contact with used oil may irri-
tate skin.
• Keep new and used oil away from chil-
dren and pets.
• Wear a long-sleeve shirt and water-
proof gloves when handling oil.
• Wash with soap if oil contacts your
skin.
• Launder any clothing or rags that are
wet with oil.
NOTE:
Recycle or properly dispose of used engine oil.
Do not throw it in the trash, or pour it on the
ground, down a drain, or into the water.
UPPER LIMIT
LOWER LIMIT

GEAR OIL

To check the gear oil level, adjust the engine to
an upright position, remove the gear oil level
plug 1 and look into the hole. The oil level
should be at the bottom edge of the hole. If the
oil level is low, add the specified gear oil until
the level reaches the bottom edge of the hole.
Then, reinstall and tighten the plug.
Periodic gear oil replacement is essential for
long life of your outboard motor.
To change the gear oil:
1. Make sure the motor is in an upright posi-
tion. Place a drain pan under the lower cas-
ing.
2. Remove the gear oil drain plug 2, then
remove the gear oil level plug 1.
3. After the oil has drained completely, inject
the specified gear oil into the gear oil drain
hole 2 until it just starts to come out of the
gear oil level hole 1. Approximately 1100 ml
(37.2/38.7 US/lmp oz.) will be required.
59