Manual Tilting; Tilt Lever - Suzuki DF250AP Manuel Du Propriétaire

MANUAL TILTING

If you are unable to tilt the motor using the
"Power Trim and Tilt" because of an electrical
problem or some other problem, you can move
the motor manually. To tilt the motor up or
down, turn the manual release screw A two
turns counterclockwise, move the motor to the
desired position, then retighten the release
screw.
 CAUTION
The motor is very heavy. When you tilt it
manually, you could injure your back or
slip and fall causing injury.
When you tilt the motor manually, ensure
that your grip and footing are secure and
that you are able to support the weight of
the engine.
36

TILT LEVER

The Tilt Lever is provided so you can support
the motor in a tilted position for non-moving
engine support.
To set the Tilt Lever:
1. Tilt the motor all the way up by pressing the
Power Trim and Tilt "UP" switch.
2. Pull down the Tilt Lever as shown in the illus-
tration.
3. Lower the motor by pressing the Power Trim
and Tilt "DOWN" switch, until the motor is
supported by the Tilt Lever.
4. Continue to operate the Power Trim and Tilt
"DOWN" switch until the trim rods are com-
pletely retracted.