Control Handle Adjustment; Idle Speed Adjustment; Motor Cover Fastening Adjustment - Suzuki DF250AP Manuel Du Propriétaire

CONTROL HANDLE ADJUSTMENT

The control handle friction and control handle
detent force can be adjusted to suit operator's
preference. The control handle friction adjust-
ment will change the overall effort to move the
control handle. This will help prevent undesired
movement of the control handle in rough water
conditions. Consult your authorized Suzuki
marine dealer to adjust the control handle fric-
tion and detent force.
Type A
Type B
Type
A Friction and detent force
B

IDLE SPEED ADJUSTMENT

The idle speed has been factory adjusted
between 600 – 700 r/min. in neutral.
NOTE:
If idle speed cannot be set within the specified
range, contact your authorized Suzuki Marine
Dealer.
Adjustable item
Friction
MOTOR COVER FASTENING
ADJUSTMENT
If you feel motor cover fastening is loose or too
tight when locking the levers, adjust as follows:
1. Loosen the bolts 1, 2 and 3.
2. Adjust the position of fasteners 4, 5 and
6. To increase the fastening, move the fas-
teners to the direction A. To decrease the
fastening, move the fasteners to the direc-
tion B.
3. Tighten the bolts.
Motor cover
19