Replacing The Top Burner Pilot Light Nozzle - Angelo Po 291FAGF Manuel D'utilisation Et D'installation

5 - Undo the locking screw (E).
6 - Extract the bushing (F) and replace it with the
one suitable for the type of gas in use (see table
at back of manual).
7 - Adjust the position of the bushing(F) (see page
25)
8 - Tighten the screw (E).
9 - Replace the panel (D) and the rack (C) on com-
pletion of the operation.

REPLACING THE TOP BURNER PILOT LIGHT NOZZLE

To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
2 - Pull off the knob (A).
3 - Undo the screws (C) and remove the con-
trol panel (B).
4 - Remove the pipe (D).
5 - Remove the nozzle (E) and replace it with
the one suitable for the type of gas in use (see
table at back of manual).
6 - Replace the pipe (D), the control panel (B) and
the control knobs (A).
IT
GB
DE
REPLACING OVEN BURNER PILOT LIGHT NOZZLE
To carry out this operation, proceed as follows.
FR
1 - Access the pilot light through the opening provi-
ded in the bottom of the appliance.
ES
2 - Unscrew the cap (B).
3 - Remove the nozzle (C) and replace it with the
one suitable for the type of gas in use (see table
at back of manual).
4 - Replace the cap (B).
English
E
F
C
A C B
- 30 -
IDM-39617002800.tif
D E
10
IDM-39614602800.tif
C
B
IDM-39614602900.tif