Replacing The Top Burner Pilot Light Nozzle; Decommissioning The Appliance - Angelo Po 1G1FA0E Manuel D'utilisation Et D'installation

REPLACING THE TOP BURNER PILOT LIGHT NOZZLE

To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
2 - Pull off the knob (A).
3 - Undo the screws (C) and remove the control
panel (B).
4 - Remove the pipe (D).
REPLACING THE FAN MOTOR (1G1FA0EV)
To carry out this operation,
proceed as follows.
1 - Turn off the gas supply
tap.
2 - Open the oven door (A).
3 - Undo the screws (B) and
IT
remove the casing (C).
4 - Undo the screws (D).
GB
5 - Pull off and extract the
motor support (E) without
DE
pulling the electric cable.
6 - Disconnect the connector
(F).
FR
7 - Remove the fan (G).
8 - Undo the screws (H), re-
ES
move the motor (L) and
replace it.
9 - Return the appliance to its initial configuration.

DECOMMISSIONING THE APPLIANCE

Important
This operation must be carried out by
skilled operatives in compliance with the le-
gal requirements with regard to safety at
work. Never dump non-biodegradable ma-
terials, lubricating oils and non-metallic
English
B
A
C B
5 - Remove the nozzle (E) and replace it with the
one suitable for the type of gas in use (see table
at back of manual).
6 - Replace the pipe (D), the control panel (B) and
the control knobs (A).
D
C
A
F
D
E
components (rubber, PVC, resins, etc.) in
the environment. Dispose of them in ac-
cordance with the relevant legal require-
ments.
- 24 -
E
10
IDM-39618301700.tif
H
G
IDM-39604016500.tif
L