Cleaning The Hob, Burners And Accessories; Cleaning Oven - Angelo Po 291FAGF Manuel D'utilisation Et D'installation

To carry out this operation, proceed as follows.
1 - Remove the burner cap (A) and the burner (B).
2 - Clean the burner and the flame cap thoroughly
and check that the holes in it are not blocked.
3 - Clean the ignition slot in the burner regularly.
4 - Clean the hob.
5 - After use, clean the accessories with a suitable
grease-remover product. If possible, wash in
the dishwasher.
6 - Dry the surfaces and reassemble the components.
For correct burner assembly, follow the instructions
shown in the figure.
Caution - warning
Never pour water or allow dirt to fall into the
burner as this will cause the burner to mal-
function or block the nozzle.
To carry out this operation, proceed as follows.
1 - Switch the appliance off and leave it to cool.
2 - Turn off the circuit-breaker to disconnect it from
IT
IT
the electrical mains.
3 - Remove the bottom plate (C) and the grid (D)
GB GB
from the oven and clean them thoroughly.
4 - Clean the inside parts of the oven to remove
DE DE
any deposits which may impair its operation.
5 - Dry the surfaces and reassemble the compo-
nents.
FR FR
6 - Clean the rubber gasket on the oven door
(avoid the use of corrosive products and do
ES ES
not use abrasive materials or sharp tools).
Important
If the gasket is damaged, do not use the
oven and contact the after-sales service.
English

CLEANING THE HOB, BURNERS AND ACCESSORIES

CLEANING OVEN

D
C
- 14 -
A
B
IDM-39614600900.tif
IDM-39617001100.tif