Technical Data; Safety Devices; Safety And Information Signs - Angelo Po 291FAGF Manuel D'utilisation Et D'installation

See tables and "Connection chart" at the back of
the manual.
Although the appliance is complete with all safety
devices, during installation and connection additio-
nal devices must be added if necessary to comply
with the relevant legal requirements.
The illustration shows the position of the devices.
A)Gas supply tap: for turning the connection to the
gas supply line on and off.
B)Safety thermocouple: cuts out the gas supply if
the flame goes out
C)Safety thermostat: cuts off the gas supply to the
burner in case of valve malfunction.
Caution - warning
Make a daily check that the safety devi-
ces are properly installed and in good
working order.
The illustration shows the position of the signs pro-
IT
IT
vided.
A)Nameplate with manufacturer and appliance
GB GB
data.
B)General hazard: read the manual carefully be-
DE DE
fore carrying out any procedure.
C)General hazard: when washing the appliance do
FR FR
not point pressurised water jets at internal parts.
D)General hazard: all relevant regulations must be
ES ES
complied with. "Install in compliance with the rel-
evant regulations and use in well ventilated
premises only".
E)General hazard: all relevant regulations must be
complied with. "No liability is accepted in case of
failure to comply with the installation and com-
missioning instructions".
F) Burn hazard: watch out for hot surfaces.
G)CE marking: indicates that the appliance is com-
pliant with the relevant norms.
English

TECHNICAL DATA

SAFETY DEVICES

SAFETY AND INFORMATION SIGNS

B
G
A
H
H)WEEE symbol: indicates that the appliance is
subject to specific waste disposal regulations.
L) General hazard: Do not use the gas oven and
electric grill at the same time.
- 6 -
C
B
A
IDM-39617000300.tif
D F
E
C
IDM-39617000400.tif
L
B