Publicité
Les langues disponibles
Les langues disponibles
NOTE
The tension of a new saw chain must be checked after
a few minutes in operation, and adjusted if necessary.
To do so switch the device off, remove the battery and
apply the chain brake.
16.2 Clean guide rail oil guide groove
Remove the guide rail (7).
1.
Clean the oil guide groove of dirt with a suitable
2.
tool. Use the plastic spatula for this. Do not use
steel tools!
Attach the guide rail (7) again.
3.
16.3
Sharpening the saw chain
Effective work with the cordless chainsaw saw is only
possible if the saw chain is in good condition and
sharp. This also reduces the risk of kick-back.
Special tools are required to sharpen the saw chain;
these ensure that the chain cutting edges are sharp-
ened at the correct angle and to the correct depth.
The saw chain can be resharpened at an authorise
specialist workshop. Do not attempt to sharpen the saw
chain yourself if you do not have a suitable tool and the
necessary experience.
16.4 Maintaining the guide rail (7)
WARNING! Always wear safety gloves
Remove any burrs on the edge of the guide bar
1.
using a metal file.
Clean the groove of the guide rail (7) using a brush
2.
or compressed air. Replace the guide rail (7) as
soon as the guide nut is worn.
Turn the guide rail (7) after each use to ensure
3.
even wear.
Check the sprocket at the tip of the guide rail (7)
4.
for smooth running. If necessary, lubricate it with
a bearing oil. Let some bearing oil drip into the lu-
brication hole.
Service information
With this product, it is necessary to note that the follow-
ing parts are subject to natural or usage-related wear,
or that the following parts are required as consuma-
bles.
Wearing parts*: Saw chain, guide rail, claw stop, bat-
tery
* may not be included in the scope of delivery!
46 | GB
Approved cutting gear
Guide rails:
AP14-53-507P Kangxin:
140SDEA041 Oregon:
Saw chains:
3/8LP-53 Kangxin:
91PX052X Oregon:
Approved batteries:
BA2.0-20ProS
Approved chargers:
FC2.4-20ProS Duo
FC2.4-20ProS
Connections and repairs
Connections and repair work on the electrical equip-
ment may only be carried out by electricians.
Please provide the following information in the event
of any queries:
• Type of current for the motor
• Machine data - type plate
• Engine data - type plate
Important note in the case of repairs:
For return delivery of the device for repair, please en-
sure for safety reasons that it is free of oil and fuel when
it is sent to the service centre.
Spare parts and accessories can be obtained from our
Service Centre. To do this, scan the QR code on the
front page.
17. Disposal and recycling
Notes for packaging
www.scheppach.com
7910300703
7910100710
7910100742
7910301702
7904201702
7911401701
7904201703
The packaging materials are recy-
clable. Please dispose of packag-
ing in an environmentally friendly
manner.
Publicité
