Publicité
Les langues disponibles
Les langues disponibles
STEP 4
Installation of saddle (11) and saddle support (17).
1. Push the saddle (11) with saddle bracket into the movable
saddle slide (13) and tight it up into desired incline position.
2. Place the seat slide (13) into the holder of saddle support
(17), set it at the desired horizontally position and tighten it by
using bolt (12), washer 10//25 (27) and hand grip nut (28).
3. Insert the saddle support (17) into the provided holder
of the main frame (39) and secure at the desired position
by screwing in the quick release (24). (Note: To screw in
the quick release (24), the threaded hole in the mainframe
(39) and one of the holes in the saddle support (17) must
bealigned. Furthermore, ensure that the saddle support (17) is
not pulledout of the main frame beyond the marked maximum
position. The setting of the saddle post can be adjusted as
desired later. For this, the quickrelease (24) must be loosened
by only a few revolutions, the cap of the lock must be pulled
away and the saddle adjusted. Then secure the new setting by
tightening the quick release (24).
STEP 5
Attach the handlebar (6) at handlebar support (18).
1. Guide the handlebar (6) through the holder at handlebar
post (18), put the pulse cable (5) through the hole to the top
and close the bracket of handlebar holder.
2. Screw the handlebar (6) in desired position at the
handlebar post (18) and tighten firmly with distance tube (15)
and handlebar screw (16).
STEP 6
Attach the computer (1) at handlebar support (18).
1. Push the plug of the connecting cable (22) and pulse cable
(5) into the associated socket of the computer (1).
2. Place the computer (1) on top of handlebar support (18)
and attach it with the screws (2). The screws for assembly you
find on backside of computer.
3. Guide the handlebar cover (9L+9R) over the handlebar
ends to the handlebar support tube (18) and fasten it with the
screw (10).
11
76
12
17
27
28
39
76
10
17
13
24
5
6
15
16
1
22
9L
18
GB
18
5
2
9R
Publicité
