Wilo RAIN3 Notice De Montage Et De Mise En Service page 41

a
b
Fig. 4: Screensaver
a
b
c
Fig. 5: Active touchscreen
3.3.1 Symbols
Fig. 6: Example: activated and running rain-
water storage tank pump
3.4 Settings on control device
Installation and operating instructions • Wilo-RAIN3 • Ed.05/2024-02
Screensaver (after 30 seconds without operating step on the touchscreen)
a Menu/setting
b Information on Wilo-RAIN3
c
c Operating mode (automatic – manual)
d Pumping mode (rainwater – tap water)
d
NOTICE
Fill level percentage (d), if rainwater storage tank shape is defined in menu
5.26.
With active touchscreen
a Current pressure pump outlet
d
b Pump is in operation
c Pump has stopped
d Switch mode (automatic – manual – stop)
e e Forced switchover for tap water delivery
f Forced switchover for rainwater delivery
f
NOTICE
If the "Drives OFF" symbol is
on in menu 3.01 according to Settings on control device [" 41] section is
required.
Drives OFF
Main pump OFF
Main pump ON
Rainwater storage tank pump activated and OFF
Rainwater storage tank pump activated and ON
75cm
Rainwater storage tank fill level 75 cm, measured from the sensor installed at a
(+25cm)
height of 25 cm above the bottom of the rainwater storage tank
63%
Rainwater storage tank fill level 63%
Example
• Main and rainwater storage tank pump ON
• Extraction from the rainwater storage tank filled to 63%
• Current delivery pressure is 2.3 bar
The system pressure is set and various functions and settings are defined in the settings
menu. The system parameters, including the running time, etc. are also displayed here.
visible, the drives are "OFF". Switching
en
41