Remedy In Case Of Faults - WAGNER PowrDriver Mode D'emploi

Remedy in case of faults

Type of malfunction
A. Engine does not start
B. Engine races to high rpm or
stalls during operation
C. Engine operates, PowrDriver
does not move forward or
reverse.
D. Engine operates, PowrDriver
moves slowly in forward or
reverse.
E. Engine continues to run when
operator exits PowrDriver.
F. Engine misses during turns and
forward and reverse changes.
G. Engine runs for short time and
stops.
If you are still experiencing problems after having followed these steps, contact Wagner Customer Service
Possible cause
1. Engine switch OFF, no gas or low oil.
2. Battery empty.
3. Nobody in the driver's seat, the sensor is not
triggered.
1. Worn throttle lever, governor
1. Low hydraulic oil.
2. The gas pedal has been incorrectly adjusted.
1. Low hydraulic oil.
2. The gas pedal has been incorrectly adjusted.
1. Defective safety switch.
1. Engine oil low.
1. Fuel flow restriction.
GB
Measures for eliminating the malfunction
1. Consult engine manual.
2. Pull the starter rope
3. Sit down in the driver's seat
1. Consult engine manual.
1. Fill with hydraulic oil.
2. Use the adjustment lever for the gas pedal to correct it.
1. Fill with hydraulic oil.
2. Use the adjustment lever for the gas pedal to correct it.
1. Contact Wagner Customer Service.
1. Fill to correct oil level.
1. Consult engine manual.
12 PowrDriver