Rivacold RC Serie Instructions D'assemblage page 55

ATTENTION:
9.1.7 Maintenance and demolition of the RCSI incomplete machine
For maintenance and demolition of the INCOMPLETE MACHINE refer to the instructions in Chapter 5 – Maintenance and demolition
9.2 Models for applications with water/glycol coolants (RCSW)
ATTENTION:
9.2.1 RCSW specifications
RCSW models are made with 250 mm diameter electric fans and copper tubes. The shoulders, the fins and the housing are made of
aluminium. The screws, the washers and the nuts are made of stainless steel.
The main features of the incomplete machine can be found in Chapter 8 of this user's manual.
9.2.2 Warnings related to RCSW residual risks
NOTE:
ATTENTION:
9.2.3 RCSW safety labels
To the INCOMPLETE MACHINE are affixed the safety labels specified in Table 2 chapter 3.4. Signs concerning Safety in Chapter 3 -
Safety and technical data.
9.2.4 Proper and improper use of the RCSW incomplete machine
NOTE:
ATTENTION:
9.2.5 Technical data and features of the RCSW incomplete machine
For the identification of the INCOMPLETE MACHINE refer to the instructions in Section 3.7 – Technical data and features of the
incomplete machine Section 3.8 Technical data in Chapter 3 - Safety and technical data.
9.2.6 Transport and installation of the RCSW incomplete machine
For the transport and installation of the INCOMPLETE MACHINE refer to the instructions in Chapter 4 – Transport and installation and
to what is written below.
DANGER :
ATTENTION:
Refrigerant line connection
RCSW models are characterized by copper pipes. The input and output are identified by adhesive arrows placed on the pipes (Figure
12). Remove the adhesive from the tube before welding.
Figure 12 – Example of RCSW connections and adhesive location
The models of this range have the protrusion on the refrigerator connection side different than that on the
electrical connection side. When inserting and/or replacing the defrosting heaters in the pack and the drip
tray take as reference the maximum size of the housing to assess the correct insertion/placement of heaters
refer to what has been reported in previous chapters of this instruction booklet and implement it with what
is reported in the following pages.
in order to avoid any dangerous conditions for persons or damage to the INCOMPLETE-MACHINE caused
by residual risks, the manufacturer recommends you follow the instructions already reported in section 3.3 –
Warnings on residual risks in Chapter 3 – Safety and technical data and the instructions in the following
pages.
We deny all liability for damage to people and the environment if the machinery is not installed in
compliance with the law.
in order to avoid any dangerous conditions for persons or damage to the INCOMPLETE MACHINE caused
by proper and improper use, the manufacturer recommends you follow the rules already reported in section
3.5 – Proper and improper use of the incomplete machine in Chapter 3 – Safety And Technical Data
We deny all liability for damage to people and the environment if the machinery is not installed in
compliance with the law.
Before welding ensure that the battery is not pressurized.
We deny all liability for damage to people and the environment if the machinery is not installed in
compliance with the law.
RC-RCS Pag - 55 - REV 02 03/16
UK