Télécharger Imprimer la page

Rivacold RC Serie Instructions D'assemblage page 42

Publicité

Les langues disponibles

Les langues disponibles

UK
4.1.1 Power supplies and Utilities
The power supplies and utilities necessary (responsibility of the Purchaser) for the
consist in the supply of electrical energy.
Unless otherwise specified, the following remain responsibility of the Purchaser:
arranging the transport devices necessary to transport the
or installed;
arranging the tools necessary for assembly and installation;
arranging the auxiliary devices and consumption materials (e.g. non-flammable and rustproof detergents, materials and tools
necessary for cleaning, and covering cloths).
4.2 Transport and handling
The indications contained in this paragraph must be followed when transporting and handling the
indications which may occur during the procedure to install the
DANGER :
The following Individual Protection Devices are necessary to perform the task being examined:
When transporting or handling the
Check that the lifting equipment is suitable to the weight and size of the
Do not bump with equipment or anything else against the structure or the protections of the
The air-cooled evaporator is supplied sealed within cardboard boxes with inner wooden supports.
4.2.1 Lifting
DANGER :
The lifting operations to handle and then position the
guarantees and effective and safe lift.
To properly perform the lifting operations, follow the cautions reported below.
Never use two lifting devices at the same time.
Do not station beneath hanging loads.
If steel ropes are used, always keep an eye on the eyelet of the end of the lifting hook.
If steel ropes are used, be careful not to form harsh folds, in other words, with a curvature radius smaller than the one of the
eyelets of the rope ends.
The use of a lifting bar is recommended with certain models, in order to guarantee optimal distribution of the weights.
During the handling and installation phases, be careful not to damage the guarding and the fluid inlet/outlet collectors.
ATTENTION:
DANGER :
4.3 Installation
DANGER :
The following Individual Protection Devices are necessary to perform the task being examined:
Before proceeding with the installation, a project of the refrigeration system must have been developed, which defines:
all the components of the refrigeration system (e.g. condensing unit, evaporator, thermostatic valve, electrical panel, piping size,
any possible safety components, etc.);
placement of the system;
the Manufacturer rejects any responsibility for possible damages to things and/or persons
stemming from improper interventions performed by unqualified, untrained, or unauthorized
personnel.
PARTLY COMPLETED MACHINERY
the lifting operations must be performed under the direct supervision of a qualified mechanical
maintenance worker.
PARTLY COMPLETED MACHINERY
throughout all of these operations, follow the precautions necessary to avoid collisions and tipping over,
handling the
PARTLY COMPLETED MACHINERY
make sure there is no unauthorized personnel near the area where the lifting, handling, and
unloading operations are taking place, and always keep at a safety distance.
the Manufacturer rejects any responsibility for possible damages to things and/or persons
stemming from improper interventions performed by unqualified, untrained, or unauthorized
personnel.
PARTLY COMPLETED MACHINERY
PARTLY COMPLETED MACHINERY
PARTLY COMPLETED MACHINERY
, it is necessary to follow the cautions described below:
PARTLY COMPLETED MACHINERY
can be performed with any adequate device that
so as not to lose balance.
to operate, exclusively
to the premises where it is to be assembled
PARTLY COMPLETED MACHINERY
on the final machine.
.
PARTLY COMPLETED MACHINERY
RC-RCS Pag - 42 - REV 02 03/16
,
.

Publicité

loading