Publicité
Les langues disponibles
Les langues disponibles
3.7 Data and technical characteristics of the partly completed machinery
3.7.1 Identification plate
To identify the
PARTLY COMPLETED MACHINERY
data reported on this plate must be notified to the offices of the Manufacturer upon each request for its intervention or when ordering
spare parts. More specifically, the following data are reported on the identification plate:
code,
no. of fan motors,
no of revs (RPM),
power supply voltage (Volt/Ph/Hz),
absorption in ampere (A),
absorption in Watt (W in),
maximum operating pressure (PS),
refrigerant fluid unit: Unit 2
minimum/maximum operating temperature (TS),
serial number.
system category according to Directive 97/23 / EC (PED).
Defrosting heaters are included on the ED models; in this case, the plate also reports the following information:
no. of heaters,
absorption in Watt (W defrost),
power supply voltage (Volt/Ph/Hz).
Breakdown of the serial number
digits 1 and 2 = code that identifies the year of manufacture,
digits 3 and 4 = week of the year in which the
digits 5, 6, 7, and 8 = progressive number.
Figure 1 – Identification plate.
3.8 Technical data
All the air-cooled evaporators are equipped with axial fan motors that are not suited for additional prevalence.
The heat exchanger is in copper-aluminum, and therefore not suitable to be used in aggressive environments.
The guarding is made of aluminum. The screws, washers, and nuts are in stainless steel. The air-cooled evaporators are equipped
with axial fan motors powered with 230/1/50-60Hz. The main characteristics of the
Chapter 8 of these instructions.
4
.
T
r
a
n
s
p
o
r
t
4
.
T
r
a
n
s
p
o
r
t
4.1 General details
The installation of the
PARTLY COMPLETED MACHINERY
Before proceeding to incorporate the
supplies and the utilities necessary for the system to operate properly, following the indications reported in this Chapter and, if
necessary, consulting the Technical Office of the Manufacturer first.
ATTENTION:
DANGER :
, an identification plate has been affixed onto it (for example, in Figure 1); the identification
PARTLY COMPLETED MACHINERY
a
n
d
i
n
s
t
a
l
l
a
t
a
n
d
i
n
s
t
a
l
l
a
t
is directly performed by qualified personnel.
PARTLY COMPLETED MACHINERY
the user, once the equipment has been purchased and before its use, becomes responsible for the
component, subjected to Directive 97/93/CE (PED), and must perform the inspections by law in
accordance with the national legislature in force (M.D. 329 dated 1/12/2004 for Italy). E.g. notification of
putting into service, periodical inspection, etc.
the Manufacturer rejects any responsibility for possible damages to things and/or persons
stemming from improper interventions performed by unqualified, untrained, or unauthorized
personnel.
was manufactured,
i
o
n
i
o
n
into the final machine, you must, however, arrange the power
PARTLY COMPLETED MACHINERY
RC-RCS Pag - 41 - REV 02 03/16
UK
can be found in
Publicité
