Rivacold RC Serie Instructions D'assemblage page 54

UK
ATTENTION:
9.1.3 RCSI safety labels
To the incomplete machine are affixed safety labels. See chapter 3.4 Signs concerning Safety in Chapter 3 - Safety and technical data.
9.1.4 Proper and improper use of the RCSI incomplete machine
NOTE:
ATTENTION:
9.1.5 Technical data and features of the RCSI incomplete machine
For the identification of the INCOMPLETE MACHINE refer to the instructions in Section 3.7 – Technical data and features of the
incomplete machine Section 3.8 Technical data in Chapter 3 - Safety and technical data.
9.1.6 Transport and installation of the RCSI incomplete machine
For the transport and installation of the INCOMPLETE MACHINE refer to the instructions in Chapter 4 – Transport and installation and
to what is written below.
DANGER :
ATTENTION:
Refrigerant line connection
RCSI models feature stainless steel tubing with the ends pointing toward the side opposite to the fans (Figure 11).
Fig. 11 - Example of RCSI connections location
Prior to installation of the incomplete machine, make sure there is enough room to connect the fridge and carry out the necessary
welds. The main features of the INCOMPLETE MACHINE can be found in Chapter 8 of this user's manual.
During handling be careful to avoid damaging the ends of the pipes.
Condensate drain connection
For connection of condensate drain of RCSI models apply the same considerations and precautions as those of the RCS range.
Wiring
For wiring of RCSI models apply the same considerations and precautions as those of the RCS range.
The technical data of the different RCSI models is given in the table below:
Electrical power supply of electric fans
Valid only for ED version Electrical defrosting prepared for 400/3/50Hz.
We deny all liability for damage to people and the environment if the machinery is not installed in
compliance with the law.
in order to avoid any dangerous conditions for persons or damage to the INCOMPLETE MACHINE caused
by proper and improper use, the manufacturer recommends you follow the rules already reported in section
3.5 – Proper and improper use of the incomplete machine in Chapter 3 – Safety And Technical Data
We deny all liability for damage to people and the environment if the machinery is not installed in
compliance with the law.
Before welding ensure that the battery is not pressurized.
We deny all liability for damage to people and the environment if the machinery is not installed in
compliance with the law.
RC-RCS Pag - 54 - REV 02 03/16