ECOVACS DEEBOT Y1 Manuel D'instructions page 4

20. Do not use the Charging Dock if it is damaged. The power supply
is not to be repaired and not to be used any longer if it is damaged
or defective.
21. Do not use with a damaged power cord or receptacle. Do not use
the Appliance or Charging Dock if it is not working properly, has
been dropped, damaged, left outdoors, or come in contact with
water. It must be repaired by the manufacturer or its service agent
in order to avoid a hazard.
22. Turn OFF the power switch before cleaning or maintaining the
Appliance.
23. The plug must be removed from the receptacle before cleaning or
maintaining the Charging Dock.
24. Remove the Appliance from the Charging Dock, and turn OFF the
power switch to the Appliance before removing the battery for
disposal of the Appliance.
25. The battery must be removed and discarded according to local
laws and regulations before disposal of the Appliance.
26. Please dispose of used batteries according to local laws and
regulations.
27. Do not incinerate the Appliance even if it is severely damaged. The
batteries can explode in a re.
28. When not using the Charging Dock for a long period of time,
please unplug it.
29. The Appliance must be used in accordance with the directions
in this Instruction Manual. Ecovacs Robotics Co.,Ltd. cannot be
held liable or responsible for any damages or injuries caused by
improper use.
30. The Robot contains batteries that are only replaceable by skilled
persons. To replace the Robot's battery, please contact Customer
Service.
31. If the Robot will not be used for a long time, power OFF the Robot
for storage and unplug the Charging Dock.
WARNING:
32. For the purposes of recharging the battery, only
use the detachable supply unit CH2331 provided with the
Appliance. The lithium battery type suitable for CH2331 is Max.
EN∣4
8 cells, max. nominal voltage DC14.4V, rated capacity 4,800mAh.
The battery must be removed and discarded according to local laws
and regulations before disposal of the Appliance. To satisfy RF
exposure requirements, a separation distance of 20 cm or more should
be maintained between this device and persons during device
operation. To ensure compliance, operations at closer than this
distance is not recommended. The antenna used for this transmitter
must not be co-located in conjunction with any other antenna or
transmitter.
Device Update
Typically, some devices are updated bi-monthly, but not always so
speci c.
Some devices, especially those that went on sale more than three years
ago, will only be updated if a critical vulnerability is found and xed.