ECOVACS DEEBOT Y1 Manuel D'instructions page 27

No. Malfunction
The following problems
appear when Robot is
working: disordered cleaning
route, deviation from the
cleaning route, repeated
9 cleaning, or missing of small
areas to be cleaned. (If there
is a large area that has not
been cleaned temporarily,
Robot will automatically
clean the missing area.).
Dust leakage occurs during
10
working.
Robot reservoir drops out of
11
place during use.
Possible Causes
The wires, slippers and other objects placed
on the ground affect the normal work of the
Robot.
When the Robot climbs the steps, threshold
and door strip, the driving wheel slipped
with the ground, which will affect Robot's
judgment on the environment of the whole
house.
Work on freshly waxed and polished oors or
smooth tiles, resulting in less friction
between the Driving Wheels and the oor.
Due to the different house environment, the
Robot can not enter some areas.
The TrueMapping Distance Sensor is dirty or
covered.
The outlet of dust box is blocked.
The reservoir is not correctly installed.
Solutions
Please tidy up the scattered objects on the ground such
as wires, slippers before cleaning. If there is any area
missing, Robot will clean the missing area by itself,
please do not interfere (such as moving Robot or
blocking the route).
It is recommended to close the door of the area and
clean the area separately. After cleaning, it will return to
the starting point. Please rest assured to use it.
It is recommended that you wait for the oor wax to dry
before using.
It is suggested to tidy up the home environment to
ensure that the Robot can enter for cleaning.
Clean the TrueMapping Distance Sensor or uncover the
objects on it.
Take out the 2 in 1 Module, and clean the dust box mouth.
Make sure Robot reservoir clicks into place when installing.
27∣EN