Textron Jacobsen G-Plex III Mode D'emploi page 62

10 ADJUSTMENT
10.8 ADJUSTING SPEED CONTROL SWITCH
The speed control switch is positioned under the
control panel. The slider/switch mechanism (3) is
activated when the speed control lever is cycled
from the Transport and mow positions. .
To set the adjusting bolt, position the control lever in
the "mow" position, loosen nuts (4), and adjust bolt
until head depresses the switch plunger. Tighten
nuts. Cycle control lever to the "transport" position,
to ensure bolt head is clear of switch.
To ensure correct set-up, the cylinders MUST only
rotate when the switch is depressed. i.e the Mow
position.
10.9 SEAT ADJUSTMENT LEVER
Pull out on the adjustment lever located under the
left side of the seat. Slide the seat to the desired
position and release the lever.
en-62
JACOBSEN G-PLEX III Series: FH & FJ
SAFETY AND OPERATORS MANUAL
1. Seat Adjustment Lever
4