Textron Jacobsen G-Plex III Mode D'emploi page 55

10 ADJUSTMENT JACOBSEN G-PLEX III Series: FH & FJ
SAFETY AND OPERATORS MANUAL
10.1 CUTTING HEAD MAINTENANCE
CLEANING
The cutting heads should be washed after use each
days and dried as well as possible to prevent rust.
All cutting surfaces (reel and bedknife) should be
given a light coating of oil or other anti-rust
compound.
LUBRICATION
The lubrication fittings at each end of both the front
and rear rollers, as well as the reel bearings at each
end should be lubricated periodically (approximately
once each week). Use only enough lubricant to
1. Lubrication Fittings
keep the bearings from drying out. Too much
lubricant may drop from mower onto turf, causing
damage to the grass.
en-55