Textron Jacobsen G-Plex III Mode D'emploi page 59

10 ADJUSTMENT
10.5 REAR SWING OUT ARM
NOTE: The rear swing out arm is to allow you
easy access to the rear cutting head. The cutting
heads must be in the raised position. DO NOT
swing the arm out with the cutting heads in the
lowered position.
1. The grass catcher MUST BE removed before
you swing the arm out.
2. Release the draw latch.
3. Pull the handle and swing the rear arm and
cutting head out.
4. After you are properly seated in the
operator's seat, restart the unit and lower the
cutting heads.
5. Shut off the unit and remove the rear cutting
head for service.
6. After you have completed your servicing,
secure the cutting head to the rear arm.
7. After you are properly seated in the
operator's seat, restart the unit and raise the
cutting heads.
8. Shut off the unit and swing the rear arm back
under the unit and secure the arm with the
draw latch.
9. Install the grass catcher.
WARNING
To avoid the possibility of serious injury,
ALWAYS be properly seated in the operator's
seat while the engine is running.
NEVER attempt to drive the machine while the
rear arm is not secured by the draw latch.
Driving the machine with the rear arm out, will
result in damage to the machine and/or cause
serious injury or death of the operator and/or
bystanders.
JACOBSEN G-PLEX III Series: FH & FJ
SAFETY AND OPERATORS MANUAL
1. Draw Latch
2. Handle
en-59