Publicité
HANDLEBAR
4. Install:
9Throttle cable 1
To tube guide 2.
NOTE:
Apply the lithium soap base grease on the throt-
tle cable end and tube guide cable winding por-
tion.
5. Install:
9Roller 1
9Collar 2
NOTE:
9Apply the lithium soap base grease on the
roller sliding surface.
9Install the roller so that the "UPPER" mark a
faces upward.
9Pass the throttle cable in the groove b in the
roller
6. Install:
9Throttle cable cap 1
9Screw (throttle cable cap) 2
7. Adjust:
9Throttle grip free play
Refer to "THROTTLE CABLE ADJUST-
MENT" section in the CHAPTER 3.
8. Install:
9Cap cover 1
9. Install:
9Master cylinder 1
9Master cylinder bracket 2
9Bolt (master cylinder bracket) 3
NOTE:
9Install the bracket so that the arrow mark a
faces upward.
9First tighten the bolt on the upper side of the
master cylinder bracket, and then tighten the
bolt on the lower side.
5-44
CHAS
1 Nm (0.1 m•kg, 0.7 ft•lb)
9 Nm (0.9 m•kg, 6.5 ft•lb)
Publicité
