Publicité
FRONT BRAKE PAD INSPECTION AND REPLACEMENT
REAR BRAKE ADJUSTMENT/
EC364002
REAR BRAKE ADJUSTMENT
1. Check:
2. Adjust:
Pedal height adjustment steps:
9Loosen the locknut 1.
9Turn the adjusting nut 2 until the pedal
height a is within specified height.
9Tighten the locknut.
w
9Adjust the pedal height between the
maximum Å Å and the minimum ı ı as
shown. (In this adjustment the bolt 3 3
end b b should protrude out of the lower
adjusting nut 4 4 but not be less than 2
mm (0.08 in) c c away from the brake ped-
al 5 5 ).
9After the pedal height adjustment, make
sure that the rear brake does not drag.
EC365080
FRONT BRAKE PAD INSPECTION AND
REPLACEMENT
1. Inspect:
2. Replace:
Brake pad replacement steps:
9Remove the pad pin plug
3-19
9 Brake pedal height a
Out of specification Adjust.
Brake pedal height a a :
5 mm (0.20 in)
9 Brake pedal height
9Brake pad thickness a
Out of specification
Brake pad thickness
Standard
4.4 mm (0.17 in)
9Brake pad
INSP
ADJ
Replace as a set.
a a :
<Limit>
1.0 mm (0.04 in)
1.
Publicité
