Laufen CLEANET ALVIA Notice D'utilisation page 7

2 INTRODUCTION
2.6 REMOTE CONTROL LINKING
If needed, a remote control link process can be carried out.
Please power on the product, wait 15 seconds until the power on is complete, and then both press
rear shower and rotary button for consecutive 3 seconds at less than 10cm of the product.
Remote control will start searching for product during 60 seconds. Press STOP + REAR SHOWER on
lateral panel for 5 seconds to allow product to be linked.
EN
When the self-test process ends, 2 "beeps" are heard indicating that the remote has been linked cor-
rectly to the e-bidet. if the setting can't be finished in the 60 seconds, please re-operate it.
Do not disconnect the appliance during this proces
x2
3 s.
5 s.
1 2 3
7