Laufen CLEANET ALVIA Notice D'utilisation page 12

4 OPERATING THE SHOWER TOILET
4.1
EN
Functions may only be activated when the lid is open and the device detects a user.
If you wish to shower again, press the controller while the shower arm is retracting at the end of the
first showering procedure.
The factory setting for the water temperature is level 3.
The cleaning stops after 2 minutes if no other button is pressed.
If another function is chosen while the cleaning is taking place, the cleaning stops and the selected
function is activated. The parameters of this function can be modified through the APP.
Improper operation includes initiating the shower procedure without anyone sitting on the shower
toilet.
This may cause water damage in the surrounding area.
4.1.1 SHOWER JET INTENSITY
The jet intensity can be adjusted to one of 5 settings. You can adjust the jet intensity while
showering by turning the controller.
The jet intensity is factory preset to 3 out of a possible 5.
REAR SHOWER
Press rear shower button to activate function, If you need to stop the shower
prematurely, press the rotary button to stop.
This time can be configured through the Smart Control APP.
LADY SHOWER
Press lady shower button to activate function, If you need to stop the shower
prematurely, press the rotary button to stop.
This time can be configured through the Smart Control APP.
REAR INTENSE SHOWER
Press rear intense shower button to activate function, If you need to stop the shower
prematurely, press the rotary button to stop.
This time can be configured through the Smart Control APP.
Turn the controller rightwards to increase the jet intensity.
Turn the controller leftwards to decrease the jet intensity.
12