Laufen CLEANET ALVIA Notice D'utilisation page 21

6 CLEANING AND MAINTENANCE
6.4 FILTER CLEANING
We recommend carrying out the maintenance of the filter once every year to ensure a correct
functioning of the device.
1
1. Close the shut-off valve.
2. Remove the filter.
3. Clean the filter. Replace the filter in its position ensuring it is properly installed and reopen the shut-
off valve.
6.5 DESCALING PROCESS
The descaling process can vary depending on the region and the given water hardness. The standard
interval should be once every 1 year.
Descaling process will reduce or eliminate limescale deposits inside water path (hoses, water tank,
instant heater and nozzle tip). It is needed that the user adds some quantity of descaling agent
(descaling powder) using specific baker and following process：
1.
Assembly the beaker parts.
2.
Place the beaker in vertical position and fill it up to the mark inside.
3.
Pour the CONTENT of the descaling sachet into the beaker and mix it slightly.
4.
Manually lift the nozzle door and introduce the beaker neck inside. Make sure that it securely rests
against the porcelain.
5.
Press 3 sec. the rear shower side panel button to move the nozzle out. A long beep will be heart .
After that, press 5 sec. dryer side panel button. Three beeps will be heart and the descaling process
will start.
6.
Do not remove the beaker while the process is going on.
7.
Once the descaling process has finished, the nozzle automatically will move inside, and three sort
"beeps" are emitted. Remove the beaker from its position and the product will be ready to be used
again.
3 s.
x1
During this process, no function should work.
For descaling only use the Laufen descaling agent. It may cause damage if it is used another descaling
agent.
2
5 s.
x3
21
3
1
x1
2
30 min.
ORDER DESCALING AGENT
H8946970000001
EN
x3