Publicité
Les langues disponibles
Les langues disponibles
6 CLEANING AND MAINTENANCE
6.5
DESCALING PROCESS-REMOTE CONTROL
The descaling process can vary depending on the region and the given water hardness. The standard
interval should be once every 1 year.
Descaling process will reduce or eliminate limescale deposits inside water path (hoses, water tank,
instant heater and nozzle tip). It is needed that the user adds some quantity of descaling agent
(descaling powder) using specific baker and following process：
1. Assembly the beaker parts.
EN
2. Place the beaker in vertical position and fill it up to the mark inside.
3. Pour the CONTENT of the descaling sachet into the beaker and mix it slightly.
4. Manually lift the nozzle door and introduce the beaker neck inside. Make sure that it securely rests
against the porcelain.
5. Press rotary button and temperature button at the same time about 3 seconds on the remote
control to move the nozzle out.
Additionally, another option is using thethe rear shower side panel button to move the nozzle out.
A long beep will be heart . After that, press 5 sec. dryer side panel button. Three beeps will be heart
and the descaling process will start.
6. Do not remove the beaker while the process is going on.
7. Once the descaling process has finished, the nozzle automatically will move inside, and three sort
"beeps" are emitted. Remove the beaker from its position and the product will be ready to be used
again.
1
3
5a
a
+
3 sec
2
5b
3 sec
4
6b
a
5 sec
b
7
b
22
a
× 1
b
a
b
× 3
8
a
30 min
b
×
× 3
c
Publicité
