Dreame X40 Master Manuel D'utilisation page 36

Les langues disponibles

Disassembly Instructions

ONLY REQUIRED IN CASE OF RETURN

1. Enable the water-emptying function through the app to drain the

remaining water both in the robot and the base station.

Note: Please take out the washboard base and check whether there is a small

amount of water remaining. If so, be sure to wipe it dry and put it back again.

2. Open the function hatch manually. Place a container under the auto-

detergent compartment, then remove the sealing stopper and slightly

tilt the base station to ensure that all remaining detergent flows into the

container.Finally, put the sealing stopper back into place.

③

①

②

3. Before disassembly, unplug the base station, close the main water

valve and angle valve at home.

4. Firstly, pull out the connection locking clip. Then, press the snap ring

at the joint forcefully to disassemble the pipe. Use a container to catch

the water flowing out.

①

②

③

Note:

Do not directly pull out the water pipe forcefully to avoid damage.

· Before packaging and shipping, be sure to take out the spare caps from the

outside of the dust tank and block the elbows under the base station to prevent

water leakage.

④